Dyna-Glo KFA220DGD Instruction Manual download pdf (Page 10)

NOTICE : The major electrical components of this heater are protected by a safety fuse mounted to the PCBboard.

If your heater fails to start, check this fuse first and replace as necessary. You should also check your

power source to insure that proper voltage and frequency are being supplied to the heater.

TO STOP HEATER

1. Turn switch to “OFF” and unplug power cord.

TO RESTART HEATER

1.Wait 10 seconds after stopping heater.

2. Repeat steps under to start heater.

PIGGYBACK POWER CORD

WARNING : SHOCK HAZARD!

8. LONG TERM STORAGE OF YOUR HEATER

FUEL TANK DRAIN

1. Drain fuel tank through fuel cap opening.

(For KFA50DGD/75DGD Models Only)

2. Remove fuel drain bolt from rear bottom side of fuel tank using 3/4” socket or adjustable wrench and drain.

(For KFA125/170/210DGD Models Only. See Figure 10)

3. Using a small amount of kerosene, swirl and rinse the inside of the tank.

NEVER mix water with the kerosene as it will cause rust inside the tank.

Pour the kerosene out making sure that you remove it all.

IMPORTANT : Do not store kerosene over summer months for use during next heating season.

Using old fuel could damage heater.

4. Reinstall fuel cap. Properly dispose of old and dirty fuel. (For KFA50DGD/75DGD Models Only)

5. Reinstall fuel drain bolt to Fuel tank and tighten firmly using 3/4” socket or adjustable wrench.

(For KFA125/170/210DGD Models Only. See Figure 10)

IMPORTANT : Before reinstalling the fuel drain bolt, make sure the seal is on the bolt. If the seal is

not used the bolt cannot be installed correctly and the fuel tank will leak.

6. Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.

7. Store the heater in the original box with the original packing material and keep the USER’S

MANUAL

with the heater.

 Always cover electric outlet when not in use.

 Don’t plug and use a appliance more than 120V/60Hz 5A

current in this outlet.

Figure 10. Fuel Drain Bolt

Fuel Drain Bolt

Seal

revoC

KFA75DGD/125/170/210DGD Models only

Figure 9. Piggyback Power Cord

Outlet

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Dyna-Glo KFA220DGD Instruction Manual Page 10