Dyna-Glo RMC-95C6B Use and Care Manual download pdf (Page 10)

WICK ASSEMBLY- Check at least once a month!!

The burner assembly sits on top of the wick guide. Over time, tar deposits can

accumulate on the wick guide, and this can prevent the burner assembly from

seating properly. This can result in poor combustion, smoke, odor, etc.. To prevent

this from happening, tar deposits on the wick guide can be removed as follows:

Making sure that the heater is both cool and turned off, lower the wick to the "off" position.

Remove the batteries (located at the rear of the heater).

Remove the 2 cabinet screws. Lift off the cabinet and grill assembly as shown in

illustration. (Fig.A)

Using the wick adjuster knob, raise the top of the wick until it is even with the top

of the wick guide. Using a flat-edge screwdriver, scrape off the tar deposits.

Be careful not to allow any of the tar deposits to drop into the grooves of the wick

guide. A small vacuum cleaner can be used to remove the tar deposits that have

been scraped off. (Fig.B)

Reassemble the heater and replace the batteries.

WICK REPLACEMENT

The wick in your heater needs replacing if, after repeated cleanings, any of the following conditions still exist: slow to light,

hard movement of the wick adjuster knob, kerosene odor while burning, low heat output, slow warm up, damaged wick.

Use only a genuine replacement wick.

REPLACEMENT WICK NUMBER: Kero-World 32225, Dura Heat DH-145, Glowick 30856.

If cleaning the Wick does not improve performance, you will need to replace the wick. Refer to the "TROUBLE

SHOOTING GUIDE", see page 14, which outlines conditions under which the wick should be replaced.

DO NOT attempt to substitute any other type of wick device or a wick designed for another brand or

model heater. You could damage the heater and create a potential fire hazard.

Call customer service at 1-877-447-4768, to order a wick.

ATTENTION : The only tools needed to replace the Wick are :

A pair of pliers A flat blade screwdriver A plastic bag with a twist tie

Visit our website at: www.ghpgroupinc.com/heaters/faqs.aspx and select RMC-95C6 /RMC-95C6B for a link

to a detailed video demonstrating wick replacement.

1. Push down the manual shut-off knob and turn the wick adjustment knob

COUNTERCLOCKWISE in the direction of "OFF".

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

2. Use a screwdriver to loosen and remove

cabinet screws on either side of the heater

cabinet.

3. Use the carrying handle to lift the cabinet

straight up and away from the heater.

4. Gently pull the wick adjustment

knob off the heater.

5. Remove the cabinet base by

lifting it from the back and

tilting it forward to clear the

wick adjuster assembly.

6. Trip the pendulum on the

automatic safety shutoff

system to lower the wick.

Fig.A

Fig.B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Dyna-Glo RMC-95C6B Use and Care Manual Page 10

Comments to this Manuals