Dyna-Glo RMC-KFA120T User Manual download pdf (Page 15)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

I) FUEL VALVE

( For RMC-KFA210T Model only)

- Remove side cover screws using medium phillips screwdriver (See page 13).

- Remove upper shell (See page 9).

- Remove fan (See page 10).

- Pull fuel line (lower and upper) off the fuel valve fittings (See figure 21).

- Disconnet red and orange wires from valve connector (See figure 21).

- Remove 2 screws holding fuel valve and bracket to lower shell Using medium

phillips screw driver (See figure 21).

- Remove 2 screws holding fuel valve to Bracket using medium phillps screw driver.(See figure 21).

- Attach new fuel valve to bracket with 2 screws.

- Install new fuel valve and bracket on lower shell with 2 screws.

- Connect red and orange wires (polarity not important) to valve connector (See figue 21).

- Connect upper and lower fuel lines to fuel valve (See figure 21).

- Replace fan, upper shell, side cover.

Figure 21.

Adaptor Nozzle

Fuel Line

Hose Upper

Screw

Bracket

Valve

Low shell

Valve

Fittings

Valve Connector

Electrical Wire

Fuel Line

Hose Lower

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Dyna-Glo RMC-KFA120T User Manual Page 15