Dyna-Glo RMC-KFA120T User Manual download pdf (Page 16)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

I.) PUMP PRESSURE ADJUSTMENT

- Remove pressure gauge plug from end filter cover.

- Install accessory pressure gauge.

- Start heater (See Operation, page 8)

Allow motor to reach full speed

- Adjust pressure (Using a flat blade screwdriver)

Turn relief valve to right to increase pressure. Turn

relief valve to left to decrease pressure. Set pump

pressure below correct for pressure for each model.

- Stop heater (See Operation, page 9)

- Remove pressure gauge. Replace pressure gauge

plug in end filter cover.

NOTE: USE ONLY ORIGINAL EQUIPMENT REPLACEMENT PARTS.

Use of alternate or third party components will void any warranty and may cause unsafe

operation condition.

Pressure Gauge

Plug

Relief Valve

Pressure Gauge

MODEL PUMP PRESSURE

RMC-KFA45T 2.8 psi

RMC-KFA65T 3.5 psi

RMC-KFA120T 4.5 psi

RMC-KFA170T 6.5 psi

RMC-KFA210T 8.5 psi

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

Dyna-Glo RMC-KFA120T User Manual Page 16